Ender 3v2 BLT: use this version if you installed a CR/3D/BLTouch level sensor in the Ender 3v2.Ender 3v2 MM: if you have the Ender 3v2 near to stock then use this version (Manual Mesh).You can modify your printer to meet these requirements. A DWIN or DACAI color screen with encoder knob.A compatible control board: Creality 4.2.2, 4.2.3, 4.2.7, V24S1_301F1, V24S1_301F4 or SKR Mini E3_V3 for Ender series printers with a STM32 SoC.In order to use this firmware, your printer must meet the following requirements: This is an universal firmware that can be used in both RET6 and RCT6 STM32FX chips that have 256k or 512k Flash memory. This firmware is based on Marlin, has been optimized and has enhancements for the Creality Ender 3 V2/S1 printer. Constrain UBL within mesh bounds (#24631).Automatically reboot to apply default settings on first boot after flash.Force drawing of Z-axis value on screen redrawing.Implements a user option for centering the menu title by defining TITLE_CENTERED in configuration files.Enable support for Creality Slicer G-code file with embedded thumbnail for Ender3V2 Neo.Fix Print menu doesn't appear if start gcode contains C108 #344.Raise Z to Probe Clearance position before of a Probing Z Reference.Axis value in dash board shows actual position of the axes, including Z leveling.
Filament run-out sensor enable/disable in tune menu.Shortcut option for turning off the backlight in toolbar.AUSTRAL SPRING What's new in this release
0 kommentar(er)
